Phoenix Micro Technologies: A1000 Phoenix
Connection: Andere

a1000ph.jpg

Picture of A1000 Phoenix Motherboard
Picture of A1000 Phoenix Motherboard

Hi Res Version of Motherboard - bytes
Advert A1000 Phoenix (English) - bytes
Advert A1000 Phoenix (English) - bytes
Advert A1000 Phoenix (German) - bytes
Advert A1000 Phoenix (German) - bytes

Standard Specifications

Case Type: Uses original A1000 desktop
Processor: 68000@7.14Mhz
MMU: None
FPU: Yes, optional 68881 or 68882@20Mhz
Chipset: ECS
Kickstarts: V1.3 (on ROM)
V2.04
Note: Actually supports multiple kickstarts being fitted, with the optional switch
Bus Controller: Unknown
Expansion Slots: 1 x 100pin Zorro II slot
1 x OCS/ECS Video Slot
Standard CHIP RAM: Available with 1MB and 2MB
RAM sockets: DRAM Chip Sockets
Hard Drive Controllers: Optional SCSI-II Controller (AMD 5380)
Drive Bays: 1 x Floppy Drive Bay
Expansion Ports: 1 x 25pin Serial
1 x 25pin Parallel
1 x 23pin RGB Video
1 x 23pin External Floppy
2 x 9pin Joystick/Mouse
2 x RCA Audio (Left/Right)
1 x RJ10 Keyboard Connector
Floppy Drive: Uses original A1000 drive
Motherboard Revisions: Unknown
Battery Backed Up Clock: Yes, uses "coin" shaped batteries

The A1000 phoenix was a subscription funded replacement motherboard for the A1000, ie a totally new 3rd party motherboard which was designed to fit into the A1000 case. It was designed and manufactured by Phoenix Microtechnologies in South Australia (circa 1991). It was a totally enhanced A1000 motherboard. It came with the ECS chipset, Kickstart 1.3 (on ROM) and 2MB of RAM. Depending on your configuration preference, the RAM was either configured as 1MB Chip and 1MB Fast or as 2MB Chip. It also had an optional SCSI-II controller on the motherboard. Every motherboard has the SCSI header present, but it was optional because it required the purchase of the SCSI PAL Chip and EPROM. The A1000 phoenix also had a single Zorro II slot, but because of the limitations of the A1000 case, any Zorro II cards needed to be mounted in an external unit. An a2000 video slot was also added to the motherboard as well as a battery backed-up clock. The motherboard could either be installed manually by the user, which required the retention of some chips from the original motherboard (Paula, Denise, CPU), for installation on the new motherboard or users which lived near the manufacturing facility could have their motherboard replaced by Phoenix Microtechnologies themselves. There is estimated to have been between 500 and 1000 production units of the A1000 phoenix made.

An optional memory and IDE controller was planned which could support up to 8MB of RAM, however it is not certain if it was ever released.

Contributions to this page by:
Craig Arnoldt, Greg Helps, RiWa & Friends, Robert Wahnsiedler


Einem link gefolgt? Hier gehts zur Hauptseite

Followed a link? Please go to the Main Site