Micronik: MFD4 |
Connection: Andere |
MFD4
Hi Res Version, MFD4 - bytes
Image of PCB - bytes
Image showing modified floppy cable - bytes
The MFD4 allows the installation of two internal floppy drives in a tower, for example when rehousing an A1200 motherboard. The ribbon cable is a straight-through ribbon cable from the floppy drive header on the motherboard, to the first internal floppy drive (ie Pin 1 -> Pin 1, Pin 2 -> Pin 2 etc). From the first floppy drive to the second, wire 4 has been cut and pin 14 goes to pin 16. The other ends of 14 and 16 remain disconnected.
Cable Diagram
|=========== ===|=====================|--- |===============|=====================| |=========== ===|=====================|--- |===========/===|=====================| |===============|=====================| |===============|=====================|--- DF1: DF0: Internal floppy port
At the internal floppy port 3 wires (6, 14 and 34) are attached to the small PCB. The PCB connects to the chip beneath the floppy controller header on the A1200 and contains a jumper block labelled DF1:, DF2: and DF3:. The PCB also contains a row of 6 pins where pin 3 has been removed. It is not known what these are used for.
Contributions to this page by: Allan Müller |
Einem link gefolgt? Hier gehts zur Hauptseite
Followed a link? Please go to the Main Site